Whilst they may not be as accurate as a 3d printed one I like those that Parts By Parks make,in 1:1 all rear mopar dissys will swap,all front angled ones also will swap with each other so whether you run a dissy or mag is your choice,the twin angled setups came in late 60's. *NM*

Spotlight Hobbies

Return to Index Read Responses

Whilst they may not be as accurate as a 3d printed one I like those that Parts By Parks make,in 1:1 all rear mopar dissys will swap,all front angled ones also will swap with each other so whether you run a dissy or mag is your choice,the twin angled setups came in late 60's. *NM*

In Response To: Recommendations for a pre-wired distributer for a HEMI? -- ()

Messages In This Thread

Recommendations for a pre-wired distributer for a HEMI? --
- Look at the 3D print items out there. Now, only if someone would do fuel pumps and valves... *NM*
  - YES!!! (And windshield washer pumps, too.) *NM*
- Are you talking about early or late funny cars?..... *PIC*
- Since all stock V8 distributorts looked the same up until the electronic stuff came out, I'll recommend MAD (Morgan Automotive Detail). If it's race car stuff, I'm not too sure. *NM*
- Thanks everyone info is very helpful :-) *NM*
- Whilst they may not be as accurate as a 3d printed one I like those that Parts By Parks make,in 1:1 all rear mopar dissys will swap,all front angled ones also will swap with each other so whether you run a dissy or mag is your choice,the twin angled setups came in late 60's. *NM*

Return to Index Read Responses

Model Message Board is maintained by Spotlight Hobbies
Powered by some janky old Perl script that's incredibly fragile