Archive
Return to Index
Read Responses
Thanks everyone info is very helpful :-) *NM*
In Response To:
Recommendations for a pre-wired distributer for a HEMI? --
()
Messages In This Thread
Recommendations for a pre-wired distributer for a HEMI? --
Look at the 3D print items out there. Now, only if someone would do fuel pumps and valves... *NM*
YES!!! (And windshield washer pumps, too.) *NM*
Are you talking about early or late funny cars?..... *PIC*
Since all stock V8 distributorts looked the same up until the electronic stuff came out, I'll recommend MAD (Morgan Automotive Detail). If it's race car stuff, I'm not too sure. *NM*
Thanks everyone info is very helpful :-) *NM*
Whilst they may not be as accurate as a 3d printed one I like those that Parts By Parks make,in 1:1 all rear mopar dissys will swap,all front angled ones also will swap with each other so whether you run a dissy or mag is your choice,the twin angled setups came in late 60's. *NM*
