Messages In This Thread

• Recommendations for a pre-wired distributer for a HEMI? --
  • Look at the 3D print items out there. Now, only if someone would do fuel pumps and valves... *NM*
    • YES!!! (And windshield washer pumps, too.) *NM*
  • Are you talking about early or late funny cars?..... *PIC*
  • Since all stock V8 distributorts looked the same up until the electronic stuff came out, I'll recommend MAD (Morgan Automotive Detail). If it's race car stuff, I'm not too sure. *NM*
  • Thanks everyone info is very helpful :-) *NM*
  • Whilst they may not be as accurate as a 3d printed one I like those that Parts By Parks make,in 1:1 all rear mopar dissys will swap,all front angled ones also will swap with each other so whether you run a dissy or mag is your choice,the twin angled setups came in late 60's. *NM*