That's goofy. I'd set the body onto the fenders, then stick a sharp pencil through the window openings on each side, and mark the opposite body side where it meets the floor. That would locate the lower edge of the interior panel *NM*

Spotlight Hobbies

Return to Index Read Responses

That's goofy. I'd set the body onto the fenders, then stick a sharp pencil through the window openings on each side, and mark the opposite body side where it meets the floor. That would locate the lower edge of the interior panel *NM*

In Response To: Instructions look like this....PIC ()

Messages In This Thread

NEED ASSEMBLY HELP: Mono '37 Ford Sedan side panels. Only references--bottom of side glass/top of panel & curve of rear wheel well. Thoughts? *NM*
- How are the panels assembled in the instructions: to the inside of the body, or to the interior floor? *NM*
  - Instructions look like this....PIC
    - That's goofy. I'd set the body onto the fenders, then stick a sharp pencil through the window openings on each side, and mark the opposite body side where it meets the floor. That would locate the lower edge of the interior panel *NM*
      - That's where I'm headed. But then, I still have to fit the dash and rear seat based on how/where the side panels adhere. *NM*
- Munchie,just looked at my 37 Tudor & its1987 issue instructions,I built mine without the door windows but the rear side ones,built it approx 2yrs ago,I don't remember any fit issues & the body shell fits properly against the rear fenders/running boards & front fenders,I did
  - 1987 instructions are where my excerpt above came from. *NM*
    - That's what I've got. Thanks, Rich---PIX always help. *NM*
- Munchie...check your email, I just sent a couple of pics. *NM*
  - Will do, andyd. Thanks for the shove in the appropriate direction. *NM*

Return to Index Read Responses

Model Message Board is maintained by Spotlight Hobbies
Powered by some janky old Perl script that's incredibly fragile