find a suitable size mandrel to wrap the wire around. I usually use the shank of a small drill bit. Wrap the wire tightly around the bit, leaving a suitable amount of straight wire at each end
Once you are satisfied with the coil area, remove from the bit and lay it on the bench. Gently use your x-acto knife and press between each coil to achieve the desired spacing. . Trim excess the excess and form a bend at each end and you're done
find a suitable size mandrel to wrap the wire around. I usually use the shank of a small drill bit. Wrap the wire tightly around the bit, leaving a suitable amount of straight wire at each end
