I've been 3D printing with resin for several years now. But have recently acquired an Elegoo Centauri Carbon filament printer. My initial attempts at printing were less than successful. Dave Van was most helpful in overcoming some of the issues and provided some excellent advice on how to correct the issues I was having. Here's my first successful 3d print.

This is the 1/25 International Pickup Short Bed 1974 by Andrey Bezrodny

Here's the grille

What I've found when comparing between the two technologies is there's no one right printer. I've had problems and successes with both.

Thanks again to Dave Van for his advice and support.