Chassis just came off the printer...... *PIC*

In Response To: My first 3D automotive print I am happy with..... *PIC* ()

Mechanical shapes is what the 3D printer does best. The compound curves of car bodies not so great. But this chassis looks as good ass most resin kits and almost an injected kit. Very happy. Chassis parts are printing now. Thanks

Messages In This Thread

My first 3D automotive print I am happy with..... *PIC*
- Awesome! It is amazing how much this is catching on. *NM*
- Chassis just came off the printer...... *PIC*
  - Chassis looks like a midsize GM piece. The Stude frame should look like the Avanti frame, minus the X-member which was used only for convertibles *NM*
    - Didn't Studebaker use the same basic frame from 1953 up to & including the last of the Lark variations. *NM*
      - Same frame and suspension. Even the '53 frames (for two series of cars) weren't all-new *NM*
      - Not sure of the precise timeline, but in the early 80s, the Avanti 'revival' builds used the GM metric G-Body frame
    - Yes...not 100% correct.....but print Q is great and it looks good........doubt we will get in an injected kit. Thx *NM*
      - Nice job...... *NM*
      - You have to go with what’s out there. I haven’t run across a traditional styrene kit that’s 100% correct yet. I’m sure the Studie will look great built up. *NM*