Messages In This Thread

• Question for the board.... After seeing all these wonderful 3D builds ( Scott, Steve-o and the rest) I'm thinking it's time for me to dip my toe into the 3D ocean.....
  • Re: Question for the board.... After seeing all these wonderful 3D builds ( Scott, Steve-o and the rest) I'm thinking it's time for me to dip my toe into the 3D ocean.....
  • It's just a resin kit by other means, IMO - surfacing the body is really the major task
  • David, ........ *PIC*
    • David,......... in the lower right 1/4 of the pic above, those are all underhood parts. Engine, trans, air conditioning, radiator, etc. In the left side of the pic is the exhaust, drive shaft, center link. You won't need those for a curbside. Un needed parts for curbside. *NM*
    • Thanks for your help. *NM*
      • You're welcome. I'm looking forward to seeing what you do. *NM*
        • Scott, Would you mind if I sent you an e-mail? I'm interested in these 3d prints. *NM*
          • Yes, you can send me an email. Ask me anything. *NM*
  • Make sure you get good glass with the kit. That's key. The bodies can be sanded with enough time and patience. Look for warpage. Not the usual like in styrene, but in an overall curve in one direction. It's common. Most of all, find one you really want to build and enjoy it! *NM*