And i plan to get some 3D printed dollies. Plans for the second is to put a 60 Ford cab on it and leave the high side panels alone. Just a quick mock up of that indicates that if I use the kit chassis the wheelbase needs to be just a touch shorter. Might modify it to two wheel drive too, but not fully decided yet. I’m pretty impressed with the kit so far, but two things I’ve discovered so far to watch for. The wheel rings for the rear wheels fit very tight, I broke two of them. I didn’t remove the chrome thinking hey would stay on without glue. No big deal, was able to glue them and they’re out of view. Second, the engine mounts that are molded to the frame need to be cut back some, the passenger side hits the starter. Again, not a big deal, just something to be aware of.